VW Automatic Transmission Basic Settings

From mr-fix.info Wiki
Jump to navigation Jump to search

Transverse

DQ200

//TODO

DQ250

//TODO

DQ380; DQ381; DQ500

Procedure from Ross-Tech forum and wiki[1]

  • Temperature at least 15°C
  • Selector lever in P
  • Engine idling
  • Parking brake applied
  • Foot brake pressed firmly till the end of procedure
  1. Engine on
  2. Module 0x02 Transmission → Basic Setting → Basic settings of transmission → GO!
  3. Engine off, engine on
  4. Test drive

Longitudinal

DL501

  1. Ignition on, engine off
  2. Module 0x02 Transmission → Basic Settings → Erase counter for start/stop procedure
  3. Erase counter for start/stop procedure
  4. Engine on
  5. Module 0x02 Transmission → Basic Setting → Clutch valve calibration
  6. Module 0x02 Transmission → Basic Setting → Distance sensor calibration
  7. Ignition on, engine off
  8. Module 0x02 Transmission → Basic Setting → Reset start point of adaptation to factory settings
  9. Engine on
  10. Module 0x02 Transmission → Basic Setting → Clutch engagement point adaptation
  11. Module 0x02 Transmission → Advanced measuring values → Adaptation status of the engagement point 1 and Adaptation status of the engagement point 2
  12. Drive the vehicle and observe status of the two above channels until status shows both as broken in.
  1. ↑ https://forums.ross-tech.com/index.php?threads/16517/
Retrieved from "https://wiki.mr-fix.info/index.php?title=VW_Automatic_Transmission_Basic_Settings&oldid=309"