VW Automatic Transmission Basic Settings

Transverse

DQ200

//TODO

DQ250

//TODO

DQ381

//TODO

DQ501

//TODO

Longitudinal

DL501

1. Ignition on, engine off
2. Module 0x02 Transmission → Basic Settings → Erase counter for start/stop procedure
3. Erase counter for start/stop procedure
4. Engine on
5. Module 0x02 Transmission → Basic Setting → Clutch valve calibration
6. Module 0x02 Transmission → Basic Setting → Distance sensor calibration
7. Ignition on, engine off
8. Module 0x02 Transmission → Basic Setting → Reset start point of adaptation to factory settings
9. Engine on
10. Module 0x02 Transmission → Basic Setting → Clutch engagement point adaptation
11. Module 0x02 Transmission → Advanced measuring values → Adaptation status of the engagement point 1 and Adaptation status of the engagement point 2
12. Drive the vehicle and observe status of the two above channels until status shows both as broken in.