VW Automatic Transmission Basic Settings: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
==Transverse== | == Transverse == | ||
===DQ200=== | === DQ200 === | ||
//TODO | //TODO | ||
===DQ250=== | === DQ250 === | ||
//TODO | //TODO | ||
=== | === DQ381 === | ||
//TODO | |||
=== DQ501 === | |||
//TODO | //TODO | ||
Revision as of 12:59, 15 September 2025
Transverse
DQ200
//TODO
DQ250
//TODO
DQ381
//TODO
DQ501
//TODO
Longitudinal
DL501
- Ignition on, engine off
- Module
0x02 Transmission→Basic Settings→Erase counter for start/stop procedure - Erase counter for start/stop procedure
- Engine on
- Module
0x02 Transmission→Basic Setting→Clutch valve calibration - Module
0x02 Transmission→Basic Setting→Distance sensor calibration - Ignition on, engine off
- Module
0x02 Transmission→Basic Setting→Reset start point of adaptation to factory settings - Engine on
- Module
0x02 Transmission→Basic Setting→Clutch engagement point adaptation - Module
0x02 Transmission→Advanced measuring values→Adaptation status of the engagement point 1andAdaptation status of the engagement point 2 - Drive the vehicle and observe status of the two above channels until status shows both as
broken in.