VW Automatic Transmission Basic Settings: Difference between revisions
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 7: | Line 7: | ||
=== DQ380; DQ381; DQ500 === | === DQ380; DQ381; DQ500 === | ||
Procedure from Ross-Tech forum and wiki<ref>https://forums.ross-tech.com/index.php?threads/16517/</ref> | |||
* Temperature at least 15°C | * Temperature at least 15°C | ||
* Selector lever in | * Selector lever in <code>P</code> | ||
* Engine idling | * Engine idling | ||
* Parking brake applied | * Parking brake applied | ||
| Line 14: | Line 15: | ||
# Engine on | # Engine on | ||
# Module <code>0x02 Transmission</code> → <code>Basic Setting</code> → <code>Basic settings of transmission</code> → <code>GO! | # Module <code>0x02 Transmission</code> → <code>Basic Setting</code> → <code>Basic settings of transmission</code> → <code>GO!</code> | ||
</code> | |||
# Engine off, engine on | # Engine off, engine on | ||
# Test drive | # Test drive | ||
Latest revision as of 13:13, 15 September 2025
Transverse
DQ200
//TODO
DQ250
//TODO
DQ380; DQ381; DQ500
Procedure from Ross-Tech forum and wiki[1]
- Temperature at least 15°C
- Selector lever in
P - Engine idling
- Parking brake applied
- Foot brake pressed firmly till the end of procedure
- Engine on
- Module
0x02 Transmission→Basic Setting→Basic settings of transmission→GO! - Engine off, engine on
- Test drive
Longitudinal
DL501
- Ignition on, engine off
- Module
0x02 Transmission→Basic Settings→Erase counter for start/stop procedure - Erase counter for start/stop procedure
- Engine on
- Module
0x02 Transmission→Basic Setting→Clutch valve calibration - Module
0x02 Transmission→Basic Setting→Distance sensor calibration - Ignition on, engine off
- Module
0x02 Transmission→Basic Setting→Reset start point of adaptation to factory settings - Engine on
- Module
0x02 Transmission→Basic Setting→Clutch engagement point adaptation - Module
0x02 Transmission→Advanced measuring values→Adaptation status of the engagement point 1andAdaptation status of the engagement point 2 - Drive the vehicle and observe status of the two above channels until status shows both as
broken in.