VW Automatic Transmission Basic Settings: Difference between revisions

Latest revision as of 14:13, 15 September 2025

//TODO

//TODO

Procedure from Ross-Tech forum and wiki^[1]

Engine on
Module 0x02 Transmission → Basic Setting → Basic settings of transmission → GO!
Engine off, engine on
Test drive

Ignition on, engine off
Module 0x02 Transmission → Basic Settings → Erase counter for start/stop procedure
Erase counter for start/stop procedure
Engine on
Module 0x02 Transmission → Basic Setting → Clutch valve calibration
Module 0x02 Transmission → Basic Setting → Distance sensor calibration
Ignition on, engine off
Module 0x02 Transmission → Basic Setting → Reset start point of adaptation to factory settings
Engine on
Module 0x02 Transmission → Basic Setting → Clutch engagement point adaptation
Module 0x02 Transmission → Advanced measuring values → Adaptation status of the engagement point 1 and Adaptation status of the engagement point 2
Drive the vehicle and observe status of the two above channels until status shows both as broken in.

@@ Line 1: / Line 1: @@
-==Transverse==
+== Transverse ==
-===DQ200===
+=== DQ200 ===
+//TODO
+=== DQ250 ===
+//TODO
-===DQ250===
+=== DQ380; DQ381; DQ500 ===
+Procedure from Ross-Tech forum and wiki<ref>https://forums.ross-tech.com/index.php?threads/16517/</ref>
+* Temperature at least 15°C
+* Selector lever in <code>P</code>
+* Engine idling
+* Parking brake applied
+* Foot brake pressed firmly till the end of procedure
-===DQ351===
+# Engine on
-//TODO
+# Module <code>0x02 Transmission</code> → <code>Basic Setting</code> → <code>Basic settings of transmission</code> → <code>GO!</code>
+# Engine off, engine on
+# Test drive
 ==Longitudinal==