Aux Heater Ventilation activation in Audi
Some VAG vehicles (for example Audi Q7 4L) with some engines (for example 4.2TDI) are equipped with aux. heater from the factory. There's no remote start module (Webasto Telestart). The aux heater is controlled by the engine or climatronic module and used as a supplementary coolant heater. It turns on automatically with a cold engine. But you can add timer controls to it!
Coding for Webasto Timer support
Module 08 → Long Coding → byte 02 → bit 3 → enable
Above coding example is for Audi Q7 4L (2014, after facelift, with 4-Zone Climatronic System).
Also make sure that the aux heater options are set in MMI → Green Engineering Menu → car.
Adaptation of the Webasto logic
Module 08 → Adaptation → Channel: 3 (Aux Heater Continues To Run after Engine Turned Of) → 1(yes)/2(no)
Module 08 → Adaptation → Channel: 15 (Fan Speed in Aux Heating Mode) → 60[1]
Module 08 → Adaptation → Channel: 16 (Aux Heater in Residual Heating Mode) → 0(off)/1(on)
Module 08 → Adaptation → Channel: 19 (Aux Heater Available in ECON Mode) → 0(off)/1(on)
Telestart
Module
Location in Audi A6 4F: trunk, left side.[2]
Location in Audi Q7 4L: trunk, right side.