MQB TPMS High retrofit: Difference between revisions

From mr-fix.info Wiki
Jump to navigation Jump to search
← Older edit
No edit summary
 
(6 intermediate revisions by the same user not shown)
Line 11: Line 11:
<ref>https://www.drive2.ru/parts/vag/5q0907273b/B9bkAEAFz1g</ref>
<ref>https://www.drive2.ru/parts/vag/5q0907273b/B9bkAEAFz1g</ref>


* Module (J533)
* Module (J502)
** <code>5Q0-907-273</code> - 433MHz version
** <code>5Q0-907-273</code> - 433MHz version
** <code>5Q0-907-273</code> - 315MHz version
** <code>5Q0-907-273</code> - 315MHz version
* Sensors
* Sensors
** 315MHz
** 315MHz
** 433MHz
** <code>5Q0-907-275-F</code> - 433MHz version
* Wiring
* Wiring
* Bracket
* Bracket
** <code>5NA-907-538-A</code>
** <code>4E0-810-675-B</code>


== Wiring ==
== Wiring ==
=== Vehicle connections ===


* 12V from Terminal30a
* 12V from Terminal30a
** Power from fusebox C, fuse no. 7
** Power from fusebox C, fuse no. 7
* Ground
* Ground
** right side of luggage compartment or other ground point.
** right side of luggage compartment or aby other firm ground point
* CAN-BUS extended from one of listed:
* CAN-BUS extended from TIUL T17d, black 17-pin connector
** TIUL T17d, black 17-pin connector
** pin 5 - CAN-BUS EXT, high
*** pin 12 - CAN-BUS EXT, high
** pin 6 - CAN-BUS EXT, low
*** pin 13 - CAN-BUS EXT, low
 
=== J502 Pinout ===
 
* pin 1 - CAN-BUS EXT, low
* pin 2 - KL30a (+12V)
* pin 3 - CAN-BUS EXT, high
* pin 4 - GND


== Coding ==
== Coding ==
Line 78: Line 88:
* <code>FL_2H6907273A___ 0003.odx</code> - PQ25, PQ35, PQ47 platforms
* <code>FL_2H6907273A___ 0003.odx</code> - PQ25, PQ35, PQ47 platforms
* <code>FL_3AA907273___0012.odx</code> - PQ25 (gateway 7E0*), PQ35, PQ47 (gateway 7N0*) platforms; works only with 3AA sensors
* <code>FL_3AA907273___0012.odx</code> - PQ25 (gateway 7E0*), PQ35, PQ47 (gateway 7N0*) platforms; works only with 3AA sensors
* <code>FL_4M0907273_0010.odx</code>
* <code>FL_4M0907273_0010.odx</code> - Lamborghini
* <code>FL_5Q0907273___0011.odx</code> - PQ27 and MQB platform
* <code>FL_5Q0907273___0011.odx</code> - PQ27 and MQB platform
* <code>FL_7P6907273___0008.odx</code>
* <code>FL_7P6907273L__0003.odx</code>
* <code>FL_7P6907273L__0003.odx</code>


== Dataset ==
== Dataset ==

Latest revision as of 17:26, 14 November 2026

Direct TPMS (Tire Pressure Monitoring System) will measure pressure and temperature inside each wheel. Those measurements are shared with Instrument Cluster and Infotainment.

Based on regional regulations, there are two variations of the system: 

7K3 - TPMS High 433MHz
7K4 - TPMS High 315MHz

Parts

[1] [2]

  • Module (J502)
    • 5Q0-907-273 - 433MHz version
    • 5Q0-907-273 - 315MHz version
  • Sensors
    • 315MHz
    • 5Q0-907-275-F - 433MHz version
  • Wiring
  • Bracket
    • 5NA-907-538-A
    • 4E0-810-675-B

Wiring

Vehicle connections

  • 12V from Terminal30a
    • Power from fusebox C, fuse no. 7
  • Ground
    • right side of luggage compartment or aby other firm ground point
  • CAN-BUS extended from TIUL T17d, black 17-pin connector
    • pin 5 - CAN-BUS EXT, high
    • pin 6 - CAN-BUS EXT, low

J502 Pinout

  • pin 1 - CAN-BUS EXT, low
  • pin 2 - KL30a (+12V)
  • pin 3 - CAN-BUS EXT, high
  • pin 4 - GND

Coding

Compiled completed coding guide from public source. [3] [4] [5]

Gateway

// configure gateway so it knows that there's new hardware in the CAN-BUS.
Gateway (0x19) → Adaptation → Installation list → Tire Pressure Monitoring 1 → coded

Instrument Cluster

Instrument Cluster (0x17) → Long Coding → Byte 03 → Bit 7 (Tire Pressure Monitoring) → Active
Instrument Cluster (0x17) → Long Coding → Byte 04 → Bit 0 (Tire Pressure Monitoring Display) → Inactive
Instrument Cluster (0x17) → Long Coding → Byte 11 → Bit 2 (Tire Pressure Monitoring BAP) → Active

ABS

// below instruction is for 30-bit version of the ABS module.
// make sure that it applies to your config

// disabling indirect TPMS function
ABS (0x03) → Long Coding → Byte 27 → Bit 4, 5, 6 (TPMS Configuration) → Inactive, Inactive, Inactive
ABS (0x03) → Long Coding → Byte 28 → Bit 7 (TPMS Button BAP) → Inactive

Infotainment

// receiving data on Extended CAN-BUS
Infotainment (0x5F) → Adaptation → Car Function List BAP Gen2 → tire pressure system 0x07 msg bus → Databus Extended
Infotainment (0x5F) → Adaptation → Car Function List BAP Gen2 → tire pressure system 0x07 → Active

// showing GUI in the CAR menu
Infotainment (0x5F) → Adaptation → Car Function Adaptations Gen2 → Menu display rdk → Activated
Infotainment (0x5F) → Adaptation → Car Function Adaptations Gen2 → Menu display rdk over threshold high → Activated
Infotainment (0x5F) → Adaptation → Car Function Adaptations Gen2 → Menu display rdk standstill→ Not activated

TPMS

Firmware

Firmware decides how the module works and if it will communicate correctly with rest of the car. [6]

  • FL_2H6907273A___ 0003.odx - PQ25, PQ35, PQ47 platforms
  • FL_3AA907273___0012.odx - PQ25 (gateway 7E0*), PQ35, PQ47 (gateway 7N0*) platforms; works only with 3AA sensors
  • FL_4M0907273_0010.odx - Lamborghini
  • FL_5Q0907273___0011.odx - PQ27 and MQB platform
  • FL_7P6907273L__0003.odx

Dataset

  1. ↑ https://www.audiworld.com/forums/q5-sq5-mkii-discussion-218/za-7k9-tire-pressure-monitoring-system-3017874/
  2. ↑ https://www.drive2.ru/parts/vag/5q0907273b/B9bkAEAFz1g
  3. ↑ https://www.vwvortex.com/threads/retrofit-direct-tpms-guide.9550572/?utm_source=google&utm_medium=organic
  4. ↑ https://www.audizine.com/threads/direct-tpms-retrofit-guide.824924/
  5. ↑ https://docs.google.com/spreadsheets/d/1V-OKyWGNWASIKmDf_YrTnT22BEh8ocQ1V1qpXOTBX84/
  6. ↑ https://www.drive2.ru/parts/vag/5q0907273b/B9bkAEAFz1g
Retrieved from "https://wiki.mr-fix.info/index.php?title=MQB_TPMS_High_retrofit&oldid=416"