https://wiki.mr-fix.info/index.php?action=history&feed=atom&title=Haldex_5th_gen_service 2026-05-08T12:56:04Z Revision history for this page on the wiki MediaWiki 1.43.0 https://wiki.mr-fix.info/index.php?title=Haldex_5th_gen_service&diff=295&oldid=prev 2025-08-04T05:56:40Z

<p>Created page with &quot;== Parts == === Fluid === * OEM: &lt;code&gt;G06-017-5A2&lt;/code&gt; * BorgWarner: &lt;code&gt;2000884&lt;/code&gt; * FEBI: &lt;code&gt;101172&lt;/code&gt; === Maintenance kit === * OEM: &lt;code&gt;0CQ-598-305&lt;/code&gt; == Procedure == === Disassembly=== # Remove bolt from the filling port # Remove drain bolt # Disconnect the pump connector on the Haldex control unit # Remove two 10mm bolts holding the pump from the assembly # Remove the pump from the assembly === Cleaning === # Clean any visible contamination...&quot;</p> <p><b>New page</b></p><div>== Parts ==<br /> === Fluid ===<br /> * OEM: &lt;code&gt;G06-017-5A2&lt;/code&gt;<br /> * BorgWarner: &lt;code&gt;2000884&lt;/code&gt;<br /> * FEBI: &lt;code&gt;101172&lt;/code&gt;<br /> <br /> === Maintenance kit ===<br /> * OEM: &lt;code&gt;0CQ-598-305&lt;/code&gt;<br /> <br /> == Procedure ==<br /> === Disassembly===<br /> # Remove bolt from the filling port<br /> # Remove drain bolt<br /> # Disconnect the pump connector on the Haldex control unit<br /> # Remove two 10mm bolts holding the pump from the assembly<br /> # Remove the pump from the assembly<br /> <br /> === Cleaning ===<br /> # Clean any visible contamination from the Haldex assembly<br /> # Remove two philips screw holding the strainer on the pump<br /> # Clean the strainer from any visible contamination<br /> # Install the strainer back on the pump<br /> # Replace two seals on the pump<br /> <br /> === Assembly ===<br /> # Install the pump back in the Haldex assembly<br /> # Connect the pump connector on the Haldex control unit<br /> # Install the drain bolt<br /> # Fill the Haldex assembly with fluid until it overflows<br /> # Install the bolt on the filling port<br /> <br /> === System priming ===<br /> # &lt;code&gt;Module 22 (AWD)&lt;/code&gt; → &lt;code&gt;Output Test&lt;/code&gt; → &lt;code&gt;Haldex Clutch Actuation&lt;/code&gt; → &lt;code&gt;Close&lt;/code&gt;<br /> # Remove bolt from the filling port<br /> # If needed add fluid until it overflows<br /> # Install the bolt on the filling port<br /> <br /> === Basic Settings ===<br /> # &lt;code&gt;Module 22 (AWD)&lt;/code&gt; → &lt;code&gt;Basic Settings&lt;/code&gt; → &lt;code&gt;Pump Motor&lt;/code&gt; → &lt;code&gt;All Adaption Values&lt;/code&gt;</div>

Mr-fix