View source for Haldex 5th gen service

== Parts ==
=== Fluid ===
* OEM: <code>G06-017-5A2</code>
* BorgWarner: <code>2000884</code>
* FEBI: <code>101172</code>

=== Maintenance kit ===
* OEM: <code>0CQ-598-305</code>

== Procedure ==
=== Disassembly===
# Remove bolt from the filling port
# Remove drain bolt
# Disconnect the pump connector on the Haldex control unit
# Remove two 10mm bolts holding the pump from the assembly
# Remove the pump from the assembly

=== Cleaning ===
# Clean any visible contamination from the Haldex assembly
# Remove two philips screw holding the strainer on the pump
# Clean the strainer from any visible contamination
# Install the strainer back on the pump
# Replace two seals on the pump

=== Assembly ===
# Install the pump back in the Haldex assembly
# Connect the pump connector on the Haldex control unit
# Install the drain bolt
# Fill the Haldex assembly with fluid until it overflows
# Install the bolt on the filling port

=== System priming ===
# <code>Module 22 (AWD)</code> → <code>Output Test</code> → <code>Haldex Clutch Actuation</code> → <code>Close</code>
# Remove bolt from the filling port
# If needed add fluid until it overflows
# Install the bolt on the filling port

=== Basic Settings ===
# <code>Module 22 (AWD)</code> → <code>Basic Settings</code> → <code>Pump Motor</code> → <code>All Adaption Values</code>